While many doctors warn patients of the risks involved with receiving chiropractic treatments after surgery, chiropractic care has the potential to help people suffering with back pain after surgery, as long as they are adequately healed prior to beginning treatment.
How long after back surgery can I go to chiropractor?
Although every patient and procedure is different, it’s best to wait up to 6 months before seeking alternative treatment modalities, including chiropractic care. The most important thing you can do, however, is ensure your SWSP physician is aware of your interest in chiropractic care.
Can you ruin a spinal fusion?
Can You Damage a Spinal Fusion? Yes, you absolutely can. While methods for spine surgery have significantly improved over the years, a patient’s recovery still depends on their own diligence and dedication, so following the Dos and Don’ts of spinal fusion recovery is a must.
Can chiropractors recommend surgery?
Chiropractors do not prescribe drugs or perform surgery. They work on the spine to adjust the vertebrae when they have come out of alignment and could be interfering with nerve conduction, which can cause a host of issues in the human body.
Why would you need rods in your back?
A rod is a metal cylinder implant used in spinal surgery to stabilize a vertebral segment. In a spinal fusion surgery, a rod is used to connect screws inserted into adjacent vertebral bodies in order to prevent motion and allow fusion to occur across the disc space.
Is chiropractic safe for compression fractures?
Treatment is imperative
In many cases, however, corrective chiropractic can hold potential for relief. Chiropractic treatment for vertebral compression comes in stages. First, is stabilizing the patient to alleviate acute pain. Next comes decompression, to reduce stress on the fracture and allow it to heal.
Can you go to the chiropractor after an epidural?
Can I utilize chiropractic or physical therapy after the procedure? Absolutely. I’ve spoken a bit in the past about epidural steroid injections—this is a very common, conservative treatment option for disc problems and nerve root irritations typically occurring in the neck and low back.
Can screws come loose after spinal fusion?
Pedicle screw loosening is a common complication after spine surgeries. Traditionally, it was assessed by radiological approaches, both X-ray and CT (computed tomography) scan, while reports using mechanical method to study screw loosening after spine surgery are rare.
How should I sleep after lumbar fusion?
Another way to sleep after spinal fusion surgery is on your side. Just like sleeping on your back, sleeping on your side helps reduce pain and pressure. Try to alternate between sleeping on your left and right side to distribute the pressure and benefit your spine’s alignment.
How many years does a spinal fusion last?
For patients with the smallest surgery, lumbar disc herniation, pain after 4 years was rated 1 or 2 out of 10. For patients who had undergone the largest surgeries, long fusions, pre-op pain improved from 7/10 to 3 – 4/10 at four years.